枢轴短手柄型AV-161-1C25_乐清市特佐电器有限公司

枢轴短手柄型AV-161-1C25

特征 Characteristics
从10A到21A，种类丰富、式样齐全
符合SNAP Action 组织之寿命长操作用开关要求
备有热可塑性和热硬化性两种壳体
可使用于门开闭时电流遮断等用途上
Range from 10A to 21A, abundant of kinds stylesare all in readiness.
Conform to the demands which long-time Operation of SNAP Action Organize.
Has two shells with the characters of plasticity and hot-hardening.
Can be used to the way of shut off the electric current when the door open or closed.
额定值 Rated number

规格 Specification	额定电压 Rated voltage	非电感性负载 Nonelectrical carry				电感性负载(A) Electrical carry
		电阻性负载 Resistance oarry		灯泡负载 Bulb carry		电感性负载 Electrical carry		马达负载 Motor carry
		NC	NO	NC	NO	NC	NO	NC	NO
21A	AC 250	21		3		12		7
	DC　8 30 125 250	21 14 0.6 0.3		5 5 0.1 0.05		12 12 0.6 0.3		7 5 0.1 0.05
16A	AC 250	16		2		10		3
	DC　8 30 125 250	16 10 0.6 0.3		4 4 0.1 0.05		10 10 0.6 0.3		6 4 0.1 0.05
15A	AC 250	15		2		10		3
	DC　8 30 125 250	15 10 0.6 0.3		4 4 0.1 0.05		10 10 0.6 0.3		6 4 0.1 0.05
11A	AC 250	11		1.5		6		2
	DC　8 30 125 250	11 6 0.6 0.3		3 3 0.1 0.05		6 6 0.6 0.3		3 3 0.1 0.05
10A	AC 250	10		1.5		6		2
	DC　8 30 125 250	10 6 0.6 0.3		3 3 30.1 0.05		6 6 0.6 0.3		3 3 0.1 0.05

特性 Characteristics

操作速度 Operation speed	0.1mm至1m/S(按钮型) 0.1mm to 1m/Sec
动作频率 Action frequency	机械:600次/分电气:60次/分 Mechanically:600 times/minute Electically:60 times/Minute
接点电阻 Contact resistance	15MΩ以下(初期) Under 15mΩ(initial)
绝缘电阻 Insulation resistance	100MΩ以上(在500VDC) 100mΩ above (at 500VDC)
耐电压 Bearing voltage	非连续端子间1,000VAC,50/60Hz持续1分钟载电流与无载电流零件间与端子和接地之间1,500VAC,50/60Hz持续1分钟 Non-contact end:1,000VAC,50/60Hz for one minute Current parts and noncurrent parts and end and connect position :1,500VAC,50/60Hz for one minute
振动 Vibration	10至55HZ 复振幅误动作:1.5mm 10 to 55HZ:1.5mm pairs swing action
冲击 Hitting	机械耐久：400m/Sec2(约40G,S) 误动作耐久：100m/Sec2(约10G,S) Machine:400m/Sec2(about 40G,S) Action:100m/Sec2(about 10G,S)
周围温度 Ambient temperature	-25℃至 +80℃ -25℃ to +80℃
湿度 Humidity	85% RH 以下 Below 85% RH
使用寿命 Serve life	机械:5,000,000次以上(在额定OT值下) 电气:100,000次以上 Mechanically:5,000,000 times above(at rated ot) Electrically:100,000 times above
重量 Weight	约6.2g(按钮型) About 6.2g

安装孔加工尺寸 The Processing Installment hole Methods
安装时请用M3螺丝及杯口垫圈,弹簧垫圈坚牢地安装,锁紧扭力请在0.39~0.59N.m{4~6kgf.cm}
Please use the M3 Screw and Cup mouth Gasket and the spring Gasket should be Installed firmly, and please lock tightly.at the range from 0.39~0.59N.m{4~6kgf.cm}

注意事项 Matters needing attention
1 开关请注意不要掉落,属于低负荷量专用开关,恐造成内部机构的破损。
2 附专动轴规格者，安装时请勿将传动轴本体重量加在开关的方向。
3 高温下请勿使用，外壳使用热可塑性树脂做成，在高温下可能会使其变形损坏。
1 Please do not fall when opened or closed,for it belong to low load switch,Feared that causes the Damages of inside.
2 Attaches the Special moving axis,when it is Installed,forbid putting the weight in Special moving axis.
3 Do not use when the temperature is high.

AV系列微动开关